| |
Address: No.6, Gong Ye 2 Lu Road, Linyi Industrial Park, Linyi City, Shandong Province, P.R.China
TEL：+86-0539-8525222
+86-0539-8525333
FAX：+86-0539-8525333
Mail：jinaojixie@126.com
|
|
|
|
| FAQ |
| Common Faults and troubleshooting |
| 2009-07-31 10:56:36 |
|
(has been browse 247 times)
|
When the indemnity fog machine at work for some time, can not start, not working properly, then it should follow the characteristics (circuit, circuit, one by one to exclude gas)
1. Can not start the machine
(|) To check whether or not spark plugs, too much coke, water or oil does not enter the ignition when the spark plugs should be replaced or clean-up, and then be loaded on startup. (Note: the market to buy the two-stroke spark plug ignition should adjust for the 2.5 mm gap, you can use)
(2) to check whether the damaged diaphragm carburetor, if damaged, can be replaced at this time
(3) one-way section to check out whether or not oil, cracks or impurities enter the above there should be a one-way section removed to replace or clean up after, and then can be loaded on startup (one-way section will not install anti-installed)
(4) check whether the petrol filter cup too many impurities, poor oil, should be replaced.
(5) to check whether the breakdown of high pressure apparatus, the timely replacement of
2. The machine after a certain period of time in the use of spray in small, removal methods:
(1) to check whether the damaged diaphragm carburetor, if damaged, can be replaced at this time
(2) to check whether the spray tube excessive carbon deposition, if the use of excessive clean-up bar can be cleared
(3) to check whether the drug roadblocks set plug, should be cleared
(4) one-way gas check whether there is any impurities entering the section, there should be the one-way section removed to replace or clean up after, and then on to start (one-way section will not install anti-installed)
3. Machine valve in the open after the drug off easy and boring
(1) to check whether the damaged diaphragm carburetor, if damaged, can be replaced at this time
(2) to check whether or not section off a one-way circuit oil, cracks or impurities enter the above there should be a one-way section removed to replace or clean up after, and then can be fitted (one-way section will not install anti-loaded )
(3) If the above are checked off or not to avoid boring, please adjust the throttle.
|
|
|
|
